Configuring The Switch Temperature Alarms; Setting The Primary Temperature Threshold For The Switch - Cisco IE-3000-8TC Software Configuration Manual

Configuring IE 3000 Switch Alarms
To disable sending the alarm to a relay, to syslog, or to an SNMP server, use the no alarm facility
power-supply relay, no alarm facility power-supply notifies, or no alarm facility power-supply
syslog global configuration commands.
Note Before you can use the notifies command to send alarm traps to an SNMP server, you must first set up
the SNMP server by using the snmp-server enable traps alarms global configuration command. See
the
This example sets the power-supply monitoring alarm to the minor relay.
Switch(config) # alarm facility power-supply relay minor

Configuring the Switch Temperature Alarms

You can change the temperature thresholds for both the primary and secondary temperature alarms. You
can also change the association of the primary and secondary temperature alarms to either the major or
minor relay.
This section describes how to configure the temperature alarms on your switch. It contains this
configuration information:
•
•
•

Setting the Primary Temperature Threshold for the Switch

You can use the alarm facility temperature primary global configuration command to set low and high
temperature thresholds for the primary temperature monitoring alarm.
Beginning in privileged EXEC mode, follow these steps to set the high temperature threshold:
Command
Step 1 configure terminal
Step 2
alarm facility temperature primary
high threshold
Step 3
alarm facility temperature primary
low threshold
Step 4
end
Step 5 show alarm settings
Step 6 copy running-config startup-config (Optional) Save your entries in the configuration file.
Use the no alarm facility temperature primary high threshold global configuration command to delete
the temperature monitoring alarm configuration and return to the default setting.
This example shows how to delete the primary temperature monitoring alarm configuration and return
to the default setting.
Switch(config) # no alarm facility temperature primary high 45
Cisco IE 3000 Switch Software Configuration Guide
3-6
"Enabling SNMP Traps" section on page
Setting the Primary Temperature Threshold for the Switch, page 3-6
Setting a Secondary Temperature Threshold for the Switch, page 3-7
Associating the Temperature Alarms to a Relay, page 3-7
Purpose
Enter global configuration mode.
Set the primary high temperature threshold value. Set the threshold from
–238°F (–150°C) to 572°F (300°C).
Set the primary low temperature threshold value. Set the threshold from
–328°F (–200°C) to 482°F (250°C).
Return to privileged EXEC mode.
Verify the configuration.
Chapter 3 Configuring Cisco IE 3000 Switch Alarms
3-11.
OL-13018-03