Configuring Standard Qos; Default Standard Qos Configuration - Cisco IE-3000-8TC Software Configuration Manual

Configuring Standard QoS

•
•
•
For more information about these commands, see the command reference for this release.
Configuring Standard QoS
Before configuring standard QoS, you must have a thorough understanding of these items:
•
•
•
•
These sections contain this configuration information:
•
•
•
•
•
•
•
•

Default Standard QoS Configuration

QoS is disabled. There is no concept of trusted or untrusted ports because the packets are not modified
(the CoS, DSCP, and IP precedence values in the packet are not changed). Traffic is switched in
pass-through mode (packets are switched without any rewrites and classified as best effort without any
policing).
When QoS is enabled with the mls qos global configuration command and all other QoS settings are at
their defaults, traffic is classified as best effort (the DSCP and CoS value is set to 0) without any policing.
No policy maps are configured. The default port trust state on all ports is untrusted. The default ingress
and egress queue settings are described in the
page 36-29
Cisco IE 3000 Switch Software Configuration Guide
36-28
show mls qos maps [cos-dscp | cos-input-q | cos-output-q | dscp-cos | dscp-input-q |
dscp-output-q]
show mls qos input-queue
show running-config
The types of applications used and the traffic patterns on your network.
Traffic characteristics and needs of your network. Is the traffic bursty? Do you need to reserve
bandwidth for voice and video streams?
Bandwidth requirements and speed of the network.
Location of congestion points in the network.
Default Standard QoS Configuration, page 36-28
Standard QoS Configuration Guidelines, page 36-31
Enabling QoS Globally, page 36-32
Configuring Classification Using Port Trust States, page 36-32
Configuring a QoS Policy, page 36-39
Configuring DSCP Maps, page 36-50
DSCP-to-DSCP-mutation map or the policed-DSCP map)
Configuring Ingress Queue Characteristics, page 36-56
Configuring Egress Queue Characteristics, page 36-61
and the "Default Egress Queue Configuration" section on page
(required)
(required)
(optional, unless you need to use the
(optional)
(optional)
"Default Ingress Queue Configuration" section on
Chapter 36 Configuring QoS
(required
36-29.
OL-13018-03