Cisco IE-3000-8TC Software Configuration Manual page 552

Configuring LLDP, LLDP-MED, and Wired Location Service
Command
Step 3
{voice | voice-signaling} vlan [vlan-id
{cos cvalue | dscp dvalue}] | [[dot1p
{cos cvalue | dscp dvalue}] | none |
untagged]
Step 4 exit
Step 5 interface interface-id
Step 6 network-policy profile number
Step 7 lldp med-tlv-select network-policy
Step 8
end
Step 9 show network-policy profile
Step 10 copy running-config startup-config
Use the no form of each command to return to the default setting.
This example shows how to configure VLAN 100 for voice application with CoS and to enable the
network-policy profile and network-policy TLV on an interface:
Switch# configure terminal
Switch(config)# network-policy profile 1
Switch(config-network-policy)# voice vlan 100 cos 4
Switch(config)# exit
Switch# configure terminal
Switch# interface_id
Switch(config-if)# network-policy profile 1
Switch(config-if)# lldp med-tlv-select network-policy
This example shows how to configure the voice application type for the native VLAN with priority
tagging:
Switch(config-network-policy)# voice vlan dot1p cos 4
Switch(config-network-policy)# voice vlan dot1p dscp 34
Cisco IE 3000 Switch Software Configuration Guide
27-8
Chapter 27 Configuring LLDP, LLDP-MED, and Wired Location Service
Purpose
Configure the policy attributes:
• voice—Specify the voice application type.
• voice-signaling—Specify the voice-signaling application type.
vlan—Specify the native VLAN for voice traffic.
•
vlan-id—(Optional) Specify the VLAN for voice traffic. The
•
range is 1 to 4094.
cos cvalue—(Optional) Specify the Layer 2 priority class of
•
service (CoS) for the configured VLAN. The range is 0 to 7; the
default is 0.
• dscp dvalue—(Optional) Specify the differentiated services code
point (DSCP) value for the configured VLAN. The range is 0 to
63; the default is 0.
dot1p—(Optional) Configure the telephone to use IEEE 802.1p
•
priority tagging and use VLAN 0 (the native VLAN).
none—(Optional) Do not instruct the IP telephone about the
•
voice VLAN. The telephone uses the configuration from the
telephone key pad.
untagged—(Optional) Configure the telephone to send untagged
•
voice traffic. This is the default for the telephone.
Return to global configuration mode.
Specify the interface on which you are configuring a network-policy
profile, and enter interface configuration mode.
Specify the network-policy profile number.
Specify the network-policy TLV.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file.
OL-13018-03