Auto-Qos Configuration Example - Cisco IE-3000-8TC Software Configuration Manual

Configuring Auto-QoS

Auto-QoS Configuration Example

This section describes how you could implement auto-QoS in a network, as shown in
optimum QoS performance, enable auto-QoS on all the devices in the network.
Figure 36-10
Figure 36-10
enabled on the switches in the wiring closets at the edge of the QoS domain.
Note You should not configure any standard QoS commands before entering the auto-QoS commands. You
can fine-tune the QoS configuration, but we recommend that you do so only after the auto-QoS
configuration is completed.
Cisco IE 3000 Switch Software Configuration Guide
36-26
Auto-QoS Configuration Example Network
End stations
Identify this interface
as connected to a
trusted switch or router
IP
Identify these
interfaces as
connected to
IP
IP phones
Cisco IP phones
shows a network in which the VoIP traffic is prioritized over all other traffic. Auto-QoS is
Cisco router
To Internet
Trunk Trunk
link link
Identify these
interfaces as
connected to
IP phones
Chapter 36 Configuring QoS
Figure
Video server
172.20.10.16
Identify this interface
as connected to a
trusted switch or router
IP
IP
Cisco IP phones
36-10. For
OL-13018-03