Alarm Port - Cisco IE-4000-4TC4G-E Hardware Installation Manual

Appendix C Cable and Connectors
The USB console port uses a USB Type A to 5-pin mini-Type B cable, shown in
Type A-to-USB mini-Type B cable is not supplied. You can order an accessory kit (part number 800-
33434) that contains this cable.
When running Linux, access the USB Console using Minicom instead of Screen.
Note
Figure C-5
The RJ-45 console port uses an 8-pin RJ-45 connector (See
45-to-DB-9 adapter cable is used to connect the console port of the switch to a console PC. You need to
provide a RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a
terminal. You can order a kit (part number ACS-DSBUASYN=) containing that adapter. For console port
and adapter pinout information, see

Alarm Port

The labels for the alarm connector pin-outs are on the switch panel and are displayed in
Table C-1
Label
NO
COM
NC
IN2
REF
IN1
.
USB Type A-to-USB 5-Pin Mini-Type B Cable
Table C-5
Alarm Connector Labels (Top to Bottom)
Connection
Alarm Output Normally Open (NO) connection
Alarm Output Common connection
Alarm Output Normally Closed (NC) connection
Alarm Input 2
Alarm Input Reference Ground connection
Alarm Input 1
Table C-5 and
and Table C-6.
Cisco IE 4000 Switch Hardware Installation Guide
Connector Specifications
Figure C-5. The USB
Table C-6.) The supplied RJ-
Table C-1.
C-3