Configuring The Switch Sdm Template; Default Sdm Template; Sdm Template Configuration Guidelines - Cisco IE-3000-8TC Software Configuration Manual

Configuring the Switch SDM Template

Table 10-1
Resource
IPv4 unicast routes
IPv6 multicast groups
Directly connected IPv6 addresses
Indirect IPv6 unicast routes
IPv4 policy-based routing aces
IPv4 MAC QoS ACEs
IPv4 MAC security ACEs
IPv6 policy-based routing aces
IPv4 MAC QoS ACEs
IPv4 MAC security ACEs
The rows in the tables represent approximate hardware boundaries set when a template is selected. If a
section of a hardware resource is full, all processing overflow is sent to the CPU, seriously impacting
switch performance.
Configuring the Switch SDM Template
These sections contain this configuration information:
•
•
•

Default SDM Template

The default template is the default.

SDM Template Configuration Guidelines

Follow these guidelines when selecting and configuring SDM templates:
•
•
•
Cisco IE 3000 Switch Software Configuration Guide
10-2
Approximate Number of Feature Resources Allowed by Each Template (continued)
Default SDM Template, page 10-2
SDM Template Configuration Guidelines, page 10-2
Setting the SDM Template, page 10-3
When you select and configure SDM templates, you must reload the switch for the configuration to
take effect.
If you try to configure IPv6 features without first selecting a dual IPv4 and IPv6 template, a warning
message is generated.
Using the dual stack templates results in less TCAM capacity allowed for each resource, so do not
use if you plan to forward only IPv4 traffic.
Chapter 10
Default QoS
0 0
0 0
0 0
0 0
0 0
128 384
384 128
0 0
0 0
0 0
Configuring SDM Templates
Dual
0
0
0
0
0
0
256
0
0
0
OL-13018-03