Alarm Port; Cables And Adapters; Sfp Module Cables; Console Port Adapter Pinouts - Cisco IE 4010 Hardware Installation Manual

Cable and Connectors

Alarm Port

The alarm port uses an RJ-45 connector. See
information on alarm ratings, see
Figure 39: Alarm Port Details

Cables and Adapters

This section contains the following:

SFP Module Cables

Each port must match the wave-length specifications on each end of the cable, and for reliable communications,
the cable must not exceed the allowable length.
For more information about SFP/SFP+ modules and cables, see

Console Port Adapter Pinouts

The console port uses an 8-pin RJ-45 connector. If you did not order a console cable, you need to provide an
RJ-45-to-DB-9 adapter cable to connect the switch console port to a PC console port. You need to provide
an RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a terminal. You
can order an adapter (part number ACS-DSBUASYN=).
The following tables list the pinouts for the console port, the RJ-45-to-DB-9 adapter cable, and the console
device.
100/1000 SFP Ports, on page 5
Alarm Ratings, on page 79.
Cisco IE 4010 Switch Hardware Installation Guide
for more information. For
Transceiver Modules.
Alarm Port
63