Configuring Network-Policy Tlv - Cisco IE-3000-8TC Software Configuration Manual

Chapter 27 Configuring LLDP, LLDP-MED, and Wired Location Service
Table 27-2
LLDP-MED TLV
network-policy
power-management
Beginning in privileged EXEC mode, follow these steps to enable a TLV on an interface:
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3
lldp med-tlv-select tlv
Step 4 end
Step 5 copy running-config startup-config
This example shows how to enable a TLV on an interface:
Switch# configure terminal
Switch(config)# interface interface_id
Switch(config-if)# lldp med-tlv-select inventory-management
Switch(config-if)# end

Configuring Network-Policy TLV

Beginning in privileged EXEC mode, follow these steps to create a network-policy profile, configure the
policy attributes, and apply it to an interface.
Command
Step 1 configure terminal
Step 2 network-policy profile profile number
OL-13018-03
LLDP-MED TLVs
Description
LLDP-MED network policy TLV
LLDP-MED power management TLV
Purpose
Enter global configuration mode.
Specify the interface on which you are configuring an LLDP-MED
TLV, and enter interface configuration mode.
Specify the TLV to enable.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the network-policy profile number, and enter network-policy
configuration mode. The range is 1 to 4294967295.
Configuring LLDP, LLDP-MED, and Wired Location Service
Cisco IE 3000 Switch Software Configuration Guide
27-7