Configuring Periodic Re-Authentication - Cisco IE-3000-8TC Software Configuration Manual

Chapter 12 Configuring IEEE 802.1x Port-Based Authentication

Configuring Periodic Re-Authentication

You can enable periodic 802.1x client re-authentication and specify how often it occurs. If you do not
specify a time period before enabling re-authentication, the number of seconds between attempts
is 3600.
Beginning in privileged EXEC mode, follow these steps to enable periodic re-authentication of the client
and to configure the number of seconds between re-authentication attempts. This procedure is optional.
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3 authentication periodic
or
dot1x reauthentication
Step 4
authentication timer {{[inactivity |
reauthenticate] [server | am]} {restart
value}}
or
dot1x timeout reauth-period {seconds |
server}
Step 5 end
Step 6
show authentication interface-id
or
show dot1x interface interface-id
Step 7 copy running-config startup-config
To disable periodic re-authentication, use the no authentication periodic or the no dot1x
reauthentication interface configuration command. To return to the default number of seconds between
re-authentication attempts, use the no authentication timer or the no dot1x timeout reauth-period
interface configuration command.
OL-13018-03
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration mode.
Enable periodic re-authentication of the client, which is disabled by
default.
Set the number of seconds between re-authentication attempts.
The authentication timer keywords have these meanings:
inactivity—Interval in seconds after which if there is no activity from
•
the client then it is unauthorized
reauthenticate—Time in seconds after which an automatic
•
re-authentication attempt is be initiated
server am—Interval in seconds after which an attempt is made to
•
authenticate an unauthorized port
• restart value—Interval in seconds after which an attempt is made to
authenticate an unauthorized port
The dot1x timeout reauth-period keywords have these meanings:
• seconds—Sets the number of seconds from 1 to 65535; the default is
3600 seconds.
server—Sets the number of seconds based on the value of the
•
Session-Timeout RADIUS attribute (Attribute[27]) and the
Termination-Action RADIUS attribute (Attribute [29]).
This command affects the behavior of the switch only if periodic
re-authentication is enabled.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco IE 3000 Switch Software Configuration Guide
Configuring 802.1x Authentication
12-37