Chapter 14 Configuring Smartports Macros; Understanding Smartports Macros; Configuring Smartports Macros; Default Smartports Configuration - Cisco IE-3000-8TC Software Configuration Manual

Configuring Smartports Macros

This chapter describes how to configure Smartports macros on the IE 3000 switch.
Note For complete syntax and usage information for the commands used in this chapter, see the command
reference for this release.
•
•
•

Understanding Smartports Macros

Smartports macros provide a convenient way to save and share common configurations. You can use
Smartports macros to enable features and settings based on the location of a switch in the network and
for mass configuration deployments across the network.
Each Smartports macro is a set of CLI commands that you define. Smartports macros do not contain new
CLI commands; they are simply a group of existing CLI commands.
When you apply a Smartports macro to an interface, the CLI commands within the macro are configured
on the interface. When the macro is applied to an interface, the existing interface configurations are not
lost. The new commands are added to the interface and are saved in the running configuration file.
Configuring Smartports Macros
•
•
•

Default Smartports Configuration

There are no Smartports macros enabled on the switch.
OL-13018-03
Understanding Smartports Macros, page 14-1
Configuring Smartports Macros, page 14-1
Displaying Smartports Macros, page 14-5
Default Smartports Configuration, page 14-1
Smartports Configuration Guidelines, page 14-2
Applying Smartports Macros, page 14-3
C H A P T E R
Cisco IE 3000 Switch Software Configuration Guide
14
14-1