Mac Authentication Bypass; Maximum Number Of Allowed Devices Per Port - Cisco IE-3000-8TC Software Configuration Manual

Configuring 802.1x Authentication
•
•
•

MAC Authentication Bypass

These are the MAC authentication bypass configuration guidelines:
•
•
•
•
•

Maximum Number of Allowed Devices Per Port

This is the maximum number of devices allowed on an 802.1x-enabled port:
•
Cisco IE 3000 Switch Software Configuration Guide
12-30
After you configure a guest VLAN for an 802.1x port to which a DHCP client is connected, you
might need to get a host IP address from a DHCP server. You can change the settings for restarting
the 802.1x authentication process on the switch before the DHCP process on the client times out and
tries to get a host IP address from the DHCP server. Decrease the settings for the 802.1x
authentication process (authentication timer inactivity or dot1x timeout quiet-period) and
authentication timer reauthentication or dot1x timeout tx-period) interface configuration
commands). The amount to decrease the settings depends on the connected 802.1x client type.
When configuring the inaccessible authentication bypass feature, follow these guidelines:
The feature is supported on 802.1x port in single-host mode and multihosts mode.
–
If the client is running Windows XP and the port to which the client is connected is in the
–
critical-authentication state, Windows XP might report that the interface is not authenticated.
If the Windows XP client is configured for DHCP and has an IP address from the DHCP server,
–
receiving an EAP-Success message on a critical port might not re-initiate the DHCP
configuration process.
– You can configure the inaccessible authentication bypass feature and the restricted VLAN on
an 802.1x port. If the switch tries to re-authenticate a critical port in a restricted VLAN and all
the RADIUS servers are unavailable, switch changes the port state to the critical authentication
state and remains in the restricted VLAN.
You can configure the inaccessible bypass feature and port security on the same switch port.
–
You can configure any VLAN except an RSPAN VLAN or a voice VLAN as an 802.1x restricted
VLAN. The restricted VLAN feature is not supported on trunk ports; it is supported only on access
ports.
Unless otherwise stated, the MAC authentication bypass guidelines are the same as the 802.1x
authentication guidelines. For more information, see the
page 12-29.
If you disable MAC authentication bypass from a port after the port has been authorized with its
MAC address, the port state is not affected.
If the port is in the unauthorized state and the client MAC address is not the authentication-server
database, the port remains in the unauthorized state. However, if the client MAC address is added to
the database, the switch can use MAC authentication bypass to re-authorize the port.
If the port is in the authorized state, the port remains in this state until re-authorization occurs.
You can configure a timeout period for hosts that are connected by MAC authentication bypass but
are inactive. The range is 1to 65535 seconds. You must enable port security before configuring a
time out value. For more information, see the
In single-host mode, only one device is allowed on the access VLAN. If the port is also configured with
a voice VLAN, an unlimited number of Cisco IP phones can send and receive traffic through the voice
VLAN.
Chapter 12 Configuring IEEE 802.1x Port-Based Authentication
"802.1x Authentication" section on
"Configuring Port Security" section on page 26-8.
OL-13018-03