Vtp Configuration In Global Configuration Mode; Vtp Configuration In Vlan Database Configuration Mode; Vtp Configuration Guidelines; Domain Names - Cisco IE-3000-8TC Software Configuration Manual

Chapter 16 Configuring VTP
You access VLAN database configuration mode by entering the vlan database privileged EXEC
command.
For detailed information about vtp commands, see the command reference for this release.

VTP Configuration in Global Configuration Mode

You can use the vtp global configuration command to set the VTP password, the version, the VTP file
name, the interface providing updated VTP information, the domain name, and the mode, and to disable
or enable pruning. For more information about available keywords, see the command descriptions in the
command reference for this release. The VTP information is saved in the VTP VLAN database. When
VTP mode is transparent, the VTP domain name and mode are also saved in the switch running
configuration file, and you can save it in the switch startup configuration file by entering the copy
running-config startup-config privileged EXEC command. You must use this command if you want to
save VTP mode as transparent, even if the switch resets.
When you save VTP information in the switch startup configuration file and reboot the switch, the
switch configuration is selected as follows:
•
•

VTP Configuration in VLAN Database Configuration Mode

You can configure all VTP parameters in VLAN database configuration mode, which you access by
entering the vlan database privileged EXEC command. For more information about available keywords,
see the vtp VLAN database configuration command description in the command reference for this
release. When you enter the exit command in VLAN database configuration mode, it applies all the
commands that you entered and updates the VLAN database. VTP messages are sent to other switches
in the VTP domain, and the privileged EXEC mode prompt appears.
If VTP mode is transparent, the domain name and the mode (transparent) are saved in the switch running
configuration, and you can save this information in the switch startup configuration file by entering the
copy running-config startup-config privileged EXEC command.

VTP Configuration Guidelines

These sections describe guidelines you should follow when implementing VTP in your network.

Domain Names

When configuring VTP for the first time, you must always assign a domain name. You must configure
all switches in the VTP domain with the same domain name. Switches in VTP transparent mode do not
exchange VTP messages with other switches, and you do not need to configure a VTP domain name
for them.
OL-13018-03
If the VTP mode is transparent in the startup configuration and the VLAN database and the VTP
domain name from the VLAN database matches that in the startup configuration file, the VLAN
database is ignored (cleared), and the VTP and VLAN configurations in the startup configuration
file are used. The VLAN database revision number remains unchanged in the VLAN database.
If the VTP mode or domain name in the startup configuration do not match the VLAN database, the
domain name and VTP mode and configuration for the first 255 VLANs use the VLAN database
information.
Cisco IE 3000 Switch Software Configuration Guide
Configuring VTP
16-7