Working With Software Images - Cisco IE-3000-8TC Software Configuration Manual

Appendix B Working with the Cisco IOS File System, Configuration Files, and Software Images
Command
Step 6
configure confirm
Step 7
copy running-config
startup-config

Working with Software Images

This section describes how to archive (download and upload) software image files, which contain the
system software, the Cisco IOS code, and the embedded device manager software.
Note Instead of using the copy privileged EXEC command or the archive tar privileged EXEC command, we
recommend using the archive download-sw and archive upload-sw privileged EXEC commands to
download and upload software image files. .
You can download a switch image file from a TFTP, FTP, or RCP server to upgrade the switch software.
If you do not have access to a TFTP server, you can download a software image file directly to your PC
or workstation by using a web browser (HTTP) and then by using the device manager or Cisco Network
Assistant to upgrade your switch. For information about upgrading your switch by using a TFTP server
or a web browser (HTTP), see the release notes.
You can replace the current image with the new one or keep the current image in flash memory after a
download.
You upload a switch image file to a TFTP, FTP, or RCP server for backup purposes. You can use this
uploaded image for future downloads to the same switch or to another of the same type.
The protocol that you use depends on which type of server you are using. The FTP and RCP transport
mechanisms provide faster performance and more reliable delivery of data than TFTP. These
improvements are possible because FTP and RCP are built on and use the TCP/IP stack, which is
connection-oriented.
These sections contain this configuration information:
•
•
•
•
•
For a list of software images and the supported upgrade paths, see the release notes.
Note
OL-13018-03
Purpose
(Optional) Confirm replacement of the running configuration with a saved
configuration file.
Note
(Optional) Save your entries in the configuration file.
Image Location on the Switch, page B-24
tar File Format of Images on a Server or Cisco.com, page B-24
Copying Image Files By Using TFTP, page B-25
Copying Image Files By Using FTP, page B-28
Copying Image Files By Using RCP, page B-32
Use this command only if the time seconds keyword and argument of
the configure replace command are specified.
Cisco IE 3000 Switch Software Configuration Guide
Working with Software Images
B-23