Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 72

Catalyst 6509-NEB-A Switch
Table 1-17 Catalyst 6509-NEB-A Switch Features (continued)
Feature
Power supply
Catalyst 6500 Series Switches Installation Guide
1-52
Description
Supports one or two power supplies. The following models are
•
supported:
WS-CAC-2500W (2500 W AC-input power supply).
–
WS-CDC-2500W (2500 W DC-input power supply).
–
WS-CAC-3000W (3000 W AC-input power supply).
–
WS-CAC-4000W-US (4000 W AC-input power supply).
–
WS-CAC-4000W-INT (4000 W AC-input power supply).
–
PWR-4000-DC (4000 W DC-input power supply).
–
WS-CAC-6000W (6000 W AC-input power supply).
–
PWR-6000-DC (6000 W DC-input power supply).
–
– WS-CAC-8700W-E (8700 W AC-input power supply).
The 6000 W AC-input and DC-input power supplies and the 8700 W
Note
AC-input power supply are limited to 4500 W maximum output
when installed in the Catalyst 6509-NEB-A chassis.
• Installed power supplies can be of different ratings. Installed power
supplies can also be both AC-input, both DC-input, or one AC-input and
one DC-input. Power supplies can be configured in either redundant or
combined mode.
All Catalyst 6500 series AC-input power supplies require single-phase
•
source AC. Source AC can be out of phase between multiple power
supplies or multiple AC-power plugs on the same power supply because
all AC power supply inputs are isolated.
Note For proper operation of the power supply OUTPUT FAIL LED,
systems with single power supplies must be configured with a
minimum of one fan tray and one supervisor engine. Systems with
dual power supplies must have a minimum configuration of one fan
tray, one supervisor engine, and one additional module. Failure to
meet these minimum configuration requirements can cause a false
power supply output fail signal.
Chapter 1 Product Overview
OL-5781-08