Ac-Input Power Supplies - Cisco 6503 - Catalyst Firewall Security Sys Installation Manual

Installation guide
Hide thumbs Also See for 6503 - Catalyst Firewall Security Sys:
Table of Contents

Advertisement

Chapter 4
Removal and Replacement Procedures
Step 6
Plug the power cord into the power supply AC-in receptacle.
Connect the other end of the power cord to the AC-input power source.
Step 7
Caution
In a system with dual power supplies, connect each power supply to a separate source circuit. In case of
a power source failure, the second source will most likely still be available.
Turn the switch on the power supply to the on (|) position.
Step 8
Verify power supply operation by checking that the power supply LEDs are in the following states:
Step 9
If the LEDs indicate a power problem, see the
troubleshooting information.
Removing and Installing the 1000 W, 1300 W, 2500 W, 3000 W, 4000 W, 6000 W,
and 8700 W AC-Input Power Supplies
This section describes how to remove and install the 1000 W, 1300 W, 2500 W, 3000 W, 4000 W,
6000 W, and 8700 W AC-input power supplies in the Catalyst 6500 series switches that support them.
The section is divided into the following topics:
All six power supplies have the same basic form factor and are removed and installed using the same
procedures.
Note
Installing the 8700 W power supply in a Catalyst 6506, Catalyst 6509, or Catalyst 6509-NEB chassis
requires you to install the system ground wire on the power supply's system ground lugs rather than on
the chassis system ground pad.
In systems with redundant power supplies, you can replace the faulty supply while the system is
Note
operating.
Required Tools
You might need a flat-blade or number 2 Phillips-head screwdriver to loosen or tighten the captive
installation screws on the power supply.
OL-5781-08
INPUT OK LED is green
FAN OK LED is green
OUTPUT FAIL LED is not lit
Required Tools, page 4-9
Removing the 1000 W, 1300 W, 2500 W, 3000 W, 4000 W, 6000 W, and 8700 W AC-Input Power
Supplies, page 4-10
Installing the 1000 W, 1300 W, 2500 W, 3000 W, 4000 W, 6000 W, and 8700 W AC-Input Power
Supplies, page 4-13
Removing and Installing the AC-Input Power Supplies
"Identifying Startup Problems" section on page E-3
Catalyst 6500 Series Switches Installation Guide
for
4-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 6500 series

Table of Contents