Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 201

Chapter 3 Installing the Switch
Figure 3-49
Repeat step 3 for the remainder of the network interface cables. After routing the remaining network
Step 4
interface cables through the cable management guides, you are ready to reinstall the cable management
assembly front panel.
Position the front panel assembly and insert the front panel tab into the slot at the back of the cable guide
Step 5
system. (See
Pivot the front panel assembly down. Make sure that all of the network cables are properly routed, clear
Step 6
of the front panel and that none of them are being pinched. Align the front panel so that you can start the
two captive installation screws on the front panel.
As you reinstall the front panel assembly, make sure that all of the network cables are properly routed
Caution
over the cable guides, that all network cables maintain the proper bend radius, and that none of the
network cables are being pinched between the cable guides and the front panel assembly.
Step 7 Verify that the tab is still engaged in the slot on the back of the cable guide assembly and tighten the two
captive installation screws on the front panel assembly. (See
OL-5781-08
Routing Network Cables Through the Cable Management Assembly
Figure 3-50.)
Attaching the Interface Cables
Figure 3-51.)
Catalyst 6500 Series Switches Installation Guide
3-81