Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 194

Attaching the Interface Cables
Step 4 To install the X2 transceiver, do the following:
Insert the X2 transceiver into the transceiver socket on the supervisor engine faceplate. (See
a.
Figure
EMI gasket is flush against the system module faceplate. The X2 transceiver connector is now mated
to the socket connector.
Verify that the X2 transceiver latches are fully engaged and secure by sliding the transceiver latching
b.
sleeve toward the supervisor engine faceplate. (See
If the latches are not fully engaged, you may accidently disconnect the X2 transceiver.
Caution
Figure 3-43
Note
Catalyst 6500 Series Switches Installation Guide
3-74
3-43, top view.) Continue sliding the X2 transceiver into the socket until the X2 transceiver
Installing the 10-Gigabit X2 Transceiver
10-Gigabit X2 transceivers are keyed to prevent incorrect insertion.
Figure 3-43, bottom view.)
1
L I N
K
2
A C
T I
V E
L I N
K
A C
T I
V E
Chapter 3 Installing the Switch
OL-5781-08