Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 89

Installation guide
Hide thumbs Also See for 6503 - Catalyst Firewall Security Sys:
Table of Contents

Advertisement

Chapter 1
Product Overview
Table 1-23
Table 1-23
Catalyst 6513-E Switch Features
Feature
Chassis
Supervisor engines
Modules
Backplane bandwidth
OL-5781-08
lists the features of the Catalyst 6513-E switch chassis.
Description
Thirteen horizontal slots. Slots are numbered from (1) top to (13)
bottom.
Supports Supervisor Engine 32, Supervisor Engine 720, Supervisor
Engine 720-10GE, and Supervisor Engine 2T.
Note
Refer to your software release notes for the minimum software
release versions required to support the supervisor engines.
Supervisor Engine 32, Supervisor Engine 720, Supervisor
Engine 720-10GE, and Supervisor Engine 2T must be installed in
slot 7 and slot 8.
Slots not occupied by supervisor engines can be used for modules.
Note
Check your software release notes for any restrictions on the type of
module that can be installed.
Supervisor Engine 720, Supervisor Engine 720-10GE, and Supervisor
Engine 2T have a built-in switching fabric. Switch Fabric Modules
(WS-C6500-SFM and WS-X6500-SFM2) are not supported.
Supervisor Engine 32 does not support the Switch Fabric Modules
(WS-C6500-SFM and WS-X6500-SFM2).
The uplink ports are fully functional on all redundant supervisor engine
models when they are in standby mode.
In systems with redundant supervisor engines, both supervisor
Note
engines must be the same model and have the same daughter card
configurations. Each supervisor engine must have the resources to
run the switch on its own, which means that all supervisor engine
resources are duplicated. Identical supervisor engine memory
configurations are recommended, but are not required as long as the
supervisor engine with the smaller memory configuration is
sufficient to run the configured features of the switch. Additionally,
each supervisor engine must have its own flash device and console
port connections.
Supports up to 12 Catalyst 6500 series modules.
Slots 1–13 support dual fabric channels.
Check your software release notes for specific information on module
support. Some Catalyst 6500 series modules may:
Not be supported
Require that you install a specific supervisor engine
Have chassis slot restrictions
Require a specific software release level to operate
2 Tbps system bandwidth
80 Gbps per slot for all thirteen slots
Catalyst 6500 Series Switches Installation Guide
Catalyst 6513-E Switch
1-69

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 6500 series

Table of Contents