Online Insertion And Removal - Cisco 6503 - Catalyst Firewall Security Sys Installation Manual

Installation guide
Hide thumbs Also See for 6503 - Catalyst Firewall Security Sys:
Table of Contents

Advertisement

Removal and Replacement Procedures
In this publication, the term Catalyst 6500 series refers only to the switch chassis listed in Chapter 1.
Note
The Catalyst 6000 series switches (Catalyst 6006 and Catalyst 6009 switches) are described in a
separate publication, the Catalyst 6000 Series Switch Installation Guide.
This chapter describes how to perform the following removal and replacement procedures for the
Catalyst 6500 series field-replaceable units (FRUs):
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030

Online Insertion and Removal

The online insertion and removal (OIR) feature supported on the Catalyst 6500 series switches allows
you to remove and replace modules while the system is online. You can shut down the modules before
removal and restart them after insertion without causing other software or interfaces to shut down.
Do not remove or install more than one module at a time. After you remove or install a module, check
Note
the module LEDs before continuing.
When a module has been removed or installed, the Catalyst 6500 series switch stops processing traffic
for the module and scans the system for a configuration change. Each interface type is verified against
the system configuration, and then the system runs diagnostics on the new module. There is no disruption
to normal operation during the module insertion or removal.
OL-5781-08
Online Insertion and Removal, page 4-1
Removing and Installing the AC-Input Power Supplies, page 4-2
Removing and Installing the DC-Input Power Supplies, page 4-15
Removing and Installing PEMs, page 4-75
Removing and Installing the Fan Tray, page 4-82
Installing the Air Filter Assembly on a Catalyst 6509-NEB-A Switch or a Catalyst 6509-V-E
(Optional), page 4-93
Installing the Remote Power Cycling Feature Control Wires (Optional), page 4-98
4
C H A P T E R
Catalyst 6500 Series Switches Installation Guide
4-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 6500 series

Table of Contents