Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 217

Chapter 4 Removal and Replacement Procedures
Figure 4-6
Cable
retention
device
Power
switch
Step 6 Grasp the power supply handle with one hand, and slide the power supply part of the way out of the
chassis. Place your other hand underneath the power supply, as shown in
supply completely out of the chassis.
If the power supply bay is to remain empty, install a blank faceplate (Cisco part number 700-03104-01)
Step 7
over the opening, and secure it with the captive installation screw.
If you have removed an 8700 W power supply from either a Catalyst 6506, Catalyst 6509, or
Step 8
Catalyst 6509-NEB chassis and you have disconnected the system (NEBS) ground from the power
supply system ground studs, make sure that you reattach the system ground lug to either the chassis
system ground pad if you are not installing a new 8700 W power supply or to the system ground studs
if you are installing a new 8700 W power supply.
OL-5781-08
AC-Input Power Supply Front Panel
AC power
connection
I
0
INPU T
FAN
OUT PUT
OK
OK
FAIL
Status LEDs
Captive installation
screw
Removing and Installing the AC-Input Power Supplies
Figure
Catalyst 6500 Series Switches Installation Guide
4-7, and slide the power
4-11