Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 46

Catalyst 6506-E Switch
Table 1-9 Catalyst 6506-E Switch Features (continued)
Feature
Modules
Backplane bandwidth
Clock and VTT modules
Fan tray
Catalyst 6500 Series Switches Installation Guide
1-26
Descriptions
Supports up to five Catalyst 6500 series modules.
•
WS-C6500-SFM and WS-X6500-SFM2 Switch Fabric Modules must be
•
installed in slot 5 or slot 6.
Mixing WS-C6500-SFM and WS-X6500-SFM2 Switch Fabric
Note
Modules in the Catalyst 6506-E chassis is allowed.
Some Catalyst 6500 series modules may:
•
Not be supported
–
Require that you install a Supervisor Engine 720
–
Have chassis slot restrictions
–
Require a specific software release level to operate
–
Note Check your software release notes for specific information on
module support and restrictions.
32 GBps shared bus.
•
• 256 GBps switch fabric.
720 GBps switch fabric.
•
Two replaceable clock modules (CLK-7600=) provide clocking signals
•
to the EOBC channel and the switching bus.
Three replaceable voltage termination (VTT) modules
•
(WS-C6K-VTT-E=) provide reference voltage for bus signals.
The chassis supports one hot-swappable fan tray. One fan tray model is
•
available:
WS-C6506-E-FAN—564 CFM
–
You must install a 2500 W or higher capacity power supply in the
Note
chassis to power the fan tray. The 2500 W power supply can be
powered from either 120 VAC or 220 VAC.
The fan tray contains six individual fans. The individual fans are not
Note
field replaceable; you must replace the fan tray in the event of a fan
failure.
Fan tray STATUS LED
•
Red—One or more individual fans have failed.
–
Green—Fan tray is operating normally.
–
Chapter 1 Product Overview
OL-5781-08