Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 23

Chapter 1 Product Overview
Table 1-1
Table 1-1 Catalyst 6503 Switch Features
Feature
Chassis
Supervisor engine
Modules
OL-5781-08
lists the features of the Catalyst 6503 switch chassis.
Description
• Three horizontal slots. Slots are numbered from 1 (top) to 3 (bottom).
Supports Supervisor Engine 2, Supervisor Engine 32, Supervisor
•
Engine 32 PISA, and Supervisor Engine 720.
Refer to your software release notes for the minimum software
Note
release versions required to support the supervisor engines.
Supervisor engines can be installed in either slot 1 or slot 2.
•
Slots not occupied by supervisor engines can be used for modules.
Note
Check your software release notes for any restrictions on the type of
module that can be installed.
Supervisor Engine 720 with 10-GB uplink ports (VS-S720-10G-3C and
•
VS-S720-10G-3CXL) is not supported on the Catalyst 6503 switch
chassis.
• Supervisor Engine 32, Supervisor Engine 32 PISA, or a Supervisor
Engine 720 requires that the optional high-speed fan tray
(FAN-MOD-3HS) be installed in the chassis.
Supervisor Engine 720 has built-in switching fabric.
•
The uplink ports are fully functional on the redundant supervisor engine
•
in standby mode.
In systems with redundant supervisor engines, both supervisor
Note
engines must be the same model and have the same daughter card
configurations. Each supervisor engine must have the resources to
run the switch on its own, which means that all supervisor engine
resources are duplicated. Identical supervisor engine memory
configurations are recommended, but are not required as long as the
supervisor engine with the smaller memory configuration is
sufficient to run the configured features of the switch. Additionally,
each supervisor engine must have its own flash device and console
port connections.
Supports up to two Catalyst 6500 series modules.
•
Does not support the WS-C6500-SFM and WS-X6500-SFM2 Switch
•
Fabric Modules.
Does not support the WS-X67xx modules.
•
Some Catalyst 6500 series modules may:
•
Not be supported
–
Require that you install a Supervisor Engine 720
–
Have chassis slot restrictions
–
Require a specific software release level to operate
–
Check your software release notes for specific information.
Note
Catalyst 6500 Series Switches Installation Guide
Catalyst 6503 Switch
1-3