Rack-Mounting The Chassis - Cisco 6503 - Catalyst Firewall Security Sys Installation Manual

Installation guide
Hide thumbs Also See for 6503 - Catalyst Firewall Security Sys:
Table of Contents

Advertisement

Chapter 3
Installing the Switch

Rack-Mounting the Chassis

The chassis are designed to be mounted in equipment racks that meet ANSI/EIA 310-D and
Note
ETS 300-119 standards.
Warning
Two people are required to lift the chassis. To prevent injury, keep your back straight and lift with your
legs, not your back. Statement 164
We recommend that you have a third person to assist in this procedure.
Tip
To install the switch chassis in the equipment rack, follow these steps:
With a person standing at each side of the chassis, grasp the chassis handle with one hand, and use the
Step 1
other hand near the back of the chassis for balance. Slowly lift the chassis in unison. Avoid sudden twists
or moves to prevent injury.
Rest the back end of the chassis on the edges of the rack-mount shelf kit rails and carefully slide the
Step 2
chassis fully into the rack.
Step 3
Locate the rack post holes that align with the chassis L bracket holes. If the rack post holes are
prethreaded, determine if the threads are 10-32 or 12-24. If the rack post holes are unthreaded, install
eight or ten (four or five on each side) either 10-32 or 12-24 clip or cage nuts over the rack post holes to
accept the installation screws.
Note
Step 4
If you want to install one or both of the optional cable guide assemblies, position the cable guides so that
the cable guide mounting holes are aligned with rack-mount bracket holes and the rack post holes as
shown in
Install a minimum of eight 10-32 or 12-24 screws (four on each side) through the cable guide mounting
Step 5
holes, rack-mount L bracket holes, rack post holes, and into the clip nuts to secure the cable guides and
the chassis to the rack post. Tighten the screws securely.
OL-5781-08
Clip nuts or cage nuts are not included as part of the accessory kit that comes with the chassis.
You must obtain them yourself.
Figure
3-10.
Installing a Catalyst 6509 or Catalyst 6509-E Switch Chassis
Catalyst 6500 Series Switches Installation Guide
3-23

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 6500 series

Table of Contents