Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 320

1000 W AC-Input Power Supply
Table A-7
Specification
Power supply output
capacity
Power supply output
Output holdup time
kVA rating
Heat dissipation
Weight
1. The kVA rating listed for the power supply should be used as the sizing criteria for both UPS outputs as well as standard
circuits and transformers to power a switch.
Table A-8
Table A-8
LED
INPUT OK
FAN OK
OUTPUT FAIL
Catalyst 6500 Series Switches Installation Guide
A-12
1000 W Power Supply Specifications (continued)
Description
1000 W
15 A @ +3.3 VDC
•
5 A @ +5 VDC
•
6 A @ +12 VDC
•
20.3 A @ +42 VDC
•
20 ms minimum
1
1.25 kVA
4213 BTU/hour (approx.)
14.8 lb (6.7 kg)
list the power supply LEDs and their meanings.
1000 W Power Supply LEDs
Meaning
Green—Source AC voltage is OK. (Input voltage is 85 VAC or
•
greater.)
Off—Source AC voltage falls below 70 VAC, is not present, or the
•
power supply is turned off.
Green—Power supply fan is operating properly.
•
Off—Power supply fan failure is detected.
•
• Red—Problem with one or more of the DC-output voltages of the
power supply is detected.
• Off—DC-output voltage with acceptable margins.
Note For proper operation of the OUTPUT FAIL LED, systems with
single power supplies must be configured with a minimum of
one fan tray and one supervisor engine. Systems with dual power
supplies must have a minimum configuration of one fan tray, one
supervisor engine, and one additional module. Failure to meet
these minimum configuration requirements can cause a false
power supply output fail signal.
Appendix A Power Supply Specifications
OL-5781-08