Add / Delete Keyfob Transmitters - Visonic POWERMASTER-10 User Manual

C.5 Add / Delete Keyfob Transmitters
Each of the 8 PowerMaster-10 users may be provided with a portable keyfob transmitter to exercise better,
quicker and safer arming/disarming and other control functions. Each keyfob should be assigned with a serial
No. (1-8) that corresponds to user No. (1-8) and enrolled into the PowerMaster-10 system.
♦ Here you can add (enroll) the 8 Keyfob transmitters or delete keyfobs as required.
1. Before anything else, gather up all keyfob units you intend to enroll and make sure they all have
batteries installed and that they are active (the LED blinks upon pressing any of the buttons).
2. Carefully read the section titled "Additional Information" according to the indicated references
table at end of this section.
A. To Add (Enroll) a Keyfob
1.
KEYFOBS
2.
ADD NEW KEYFOB
3.
ENROLL NOW or
ENTR ID:xxx-xxxx
4a.
DEVICE ENROLLED
☺
Go to step 5
4b.
ID No. 300-5786
ID ACCEPTED
☺
Go to step 5
5.
K01:keyfob
ID No. 300-5786
or
K05:keyfob
☺
Return to step 2
D-302757
Enter the USER SETTINGS menu, select the [KEYFOBS] option and press
the button to confirm.
The display will read [ADD NEW KEYFOB].
To enroll a new keyfob press
The display offers you two alternative methods to enroll a keyfob:
A: ENROLL NOW: Press the AUX
several seconds until the red LED turns on and then release the button.
This procedure completes the enrollment.
If enrollment was successfully completed, a "Happy Tune"
the display reads [DEVICE ENROLLED] for a short duration and then changes
to read the keyfob's details. Continue to step 5.
B: ENTER ID (Pre-enrollment): Enter the 7-digit number that appears on
the keyfob sticker and then press
enrollment procedure see note 6 in the Additional Information table bellow.
If a valid ID was entered, a "Happy Tune"
[ID ACCEPTED] for a short duration and then changes to read the keyfob's
details. Continue to step 5.
The display shows the allocated keyfob serial No (user No.), which is always
the first free number, and the keyfob's ID number; for example:
[K01:Keyfob] alternating with [ID No. 300-5786].
If you wish to assign the keyfob to another user, for example, "User No. 5",
click the or
then press to confirm.
The display reads [
DEVICE ENROLLED
enrolled manually by entering the ID number), a "Happy Tune"
the display will then change to [
MENUS AND FUNCTIONS
2
4
.
button on the selected keyfob for
to confirm. To complete the
☺
sounds and the display reads
button until the display reads [K05:Keyfob] and
] or [
ID accepted
].
K01:Keyfob
1
etc – see
1
☺
sounds and
7
] if the keyfob was
☺
sounds and
21