Add Or Delete Keyfob Transmitters - Visonic PowerMaster-360R User Manual

Menus and functions
6
You can now enroll another proximity tag. You can also select another option in the User Settings menu (see
section A.1), or quit programming (see section A.2).
7
If no proximity tag is enrolled in the system, the display reads [
8
To cancel the procedure, press the
9
This setting can be performed only after completing steps 1 - 5 of section B.5A.

10
The symbol now appears next to the newly selected Partitions.
11
You can now repeat steps 2 - 7 to program or edit another Proximity tag.
12
You can now add or delete another proximity tag. You can also select another option in the User Settings
menu (see section A.1 and section A.2), or quit programming (see section A.3).
B.7 Add or delete keyfob transmitters
A portable keyfob transmitter may be assigned to each of the user codes 1-48 for better, quicker and safer
arming/disarming and other control functions. Each keyfob should be assigned with a serial No. 1-48 and
enrolled into the system correspondingly.
Partition Option (For information about the partition option - see Appendix B)
If the Partition option is enabled in the control panel, up to 32 keyfobs can be authorized by the Master User to
arm and disarm any combination, or all 3 partitions, irrespective of the authorization of its corresponding user
code.
 Here you can add (enroll) up to 32 Keyfob transmitters and define which of the 3 partitions each of the
keyfob will be authorized to arm and disarm, or delete keyfobs as required.
1. Before anything else, gather up all keyfob units you intend to enroll and make sure they all have

batteries installed and that they are active (the LED blinks upon pressing any of the buttons).
2. Carefully read the section titled "Additional information" according to the indicated references
see table at end of this section.
A. To add (enroll) a keyfob
1.
KEYFOBS
2.
ADD NEW KEYFOB
3.
ENROLL NOW or
ENTR ID:xxx-xxxx
4a.
DEVICE ENROLLED
☺

Go to step 5
4b.
ID No. 300-5786
ID ACCEPTED
☺

Go to step 5
5.
F01:keyfob
ID No. 300-5786
26
button.
Enter the [USER SETTINGS] menu; select the [KEYFOBS] option and press
. 1
The display will read [ADD NEW KEYFOB].
To enroll a new keyfob press
The display offers you two alternative methods to enroll a keyfob:
A: ENROLL NOW: Press and hold the AUX  button on the selected keyfob
until the LED is constantly on.
If enrollment was successfully completed, a "Success Tune" 
the display reads [DEVICE ENROLLED] for a short duration and then
changes to read the keyfob's details. Continue to step 5.
B: ENROLLMENT BY DEVICE ID: Enter the 7-digit number that appears on
the keyfob sticker and then press
enrollment procedure, see Note 9 in the Additional information table below.
If a valid ID was entered, a "Success Tune" 
reads [ID ACCEPTED] for a short duration and then changes to read the
keyfob's details. Continue to step 5.
The display shows the allocated keyfob serial No (user No.), which is always
the first free number, and the keyfob's ID number; for example:
[F01:Keyfob] alternating with [ID No. 300-5786].
NO EXISTING DEV.
].
4
.
2 This procedure completes the enrollment.
to confirm. To complete the
☺
sounds and the display
D-307084 PowerMaster-360R User's Guide
etc. –
1
☺
sounds and