Programming The Scheduler - Visonic POWERMASTER-10 User Manual

MENUS AND FUNCTIONS
C.12 Programming the Scheduler
The PowerMaster-10 system includes a PGM output that can be used to open and close an electrically-controlled
gate, or to control a preferred electrical device via keyfobs (see Chapter "Using keyfob transmitters") or according
to a programmable weekly time schedule.
♦ Here you can schedule the PGM output for up to 4 different ON/OFF time activations per any desired day or
days of the week. In addition, you can schedule a "Daily" schedule that applies to every day of the week. It is
recommended to complete the Scheduler table (placed at the end of this section) before programming the
Scheduler.
Carefully read the section titled "Additional Information" according to the indicated references
at end of this section.
A. To Select the Device No.
1.
SCHEDULER
2.
PGM
2
B. To Set the Day
Sunday
3.
or
Tuesday
4.
C. To Select the Activation No.
operation No 1
5.
or
operation No 3
6.
D. To Set the ON (Start) Time
7.
Start-HH:MM
30
Enter the USER SETTINGS menu, select the [SCHEDULER] option and
press to confirm.
The display reads [PGM]. Press
st
The 1 day of the scheduler is displayed.
Click the or
to schedule or "Daily", for example, "Tuesday".
When the "day" you wish to schedule appears on the display, press
to confirm.
3
st
The 1 operation (PGM output activation) of the scheduler is displayed.
Click the or
wish to schedule, for example, "operation No 3".
When the "operation No." you wish to schedule appears on the display, press
to confirm.
4
The "start time" screen is shown on the display.
To set the start time of the selected operation, press the
1
to enter the PGM scheduler.
button until the display reads the day you wish
button until the display reads the operation you
1
etc – see table
2
4
button.
D-302757
3