Disarming After An Alarm Or Trouble; Special Arming & Disarming Options; Switching From 'Home' To 'Away; Switching From 'Away' To 'Home - Visonic POWERMASTER-10 User Manual

Disarming after an Alarm or Trouble

After disarming, different displays may appear
indicating that the system is in a state of TROUBLE
(TRBL) or alarm MEMORY and will also sound
trouble beeps once per minute. To find out the
troubles that have been detected, or which zone
alarmed, see Chapter 3.
Upon eliminating the cause for trouble the TRBL
display will disappear, the TROUBLE indicator will
extinguish and the trouble beeps will stop.
The MEMORY message will disappear only upon
rearming the system.
IMPORTANT! If the trouble beeps bother you, disarm
the system again (even though it is already disarmed).
This will cancel the trouble beeps for 4 hours.
Special Arming & Disarming
Options
In addition to basic
provides you with several advanced arming and
disarming options:

Switching from 'HOME' to 'AWAY'

Do not disarm the system - just press
response will be the same as in ARMING AWAY above.
Vacate the premises before the exit delay expires.

Switching from 'AWAY' to 'HOME'

Do not disarm the system - simply press
Since this operation reduces the security level, the
PowerMaster-10 will ask you to key in your master
user code or user code, thus making sure that you
are an authorized user.
PRESS
[Enter code]
Move to interior zone
ARM indicator flashes during the armed state.
D-302757
OPERATING THE POWERMASTER-10 SYSTEM
arming, PowerMaster-10
RESULTANT DISPLAY
ENTER CODE _ _ _ _
Code
ARMING HOME
↓ (Exit delay) ↓
ARM HOME HH:MM

Arming AWAY or HOME 'Instant'

Pressing the
arm the system in the "Instant' mode, i.e. without an
entry delay. Therefore, any detection in any zone will
trigger an immediate alarm.
If you wish to arm AWAY-INSTANT, proceed as
follows.
PRESS
[Enter code]
Vacate the premises
ARM indicator lights during the armed state.

Forced Arming AWAY or HOME

Forced arming allows you to arm the system even if
one or more
"NOT READY" message is displayed.
Automatic forced arming operates only if this option
. The
was enabled by the installer while programming your
system. All disturbed zones will be automatically
bypassed - they will not be armed. The protected
site will not have maximum protection.
Note: When forced arming is carried out, the buzzer
"protests" by emitting a continuous tone during the exit
delay until the last 10 seconds of the delay. You can
.
silence this signal by pressing the arming button again.
If forced arming is enabled and you wish to arm the
system when NOT READY is displayed, proceed as
shown:
PRESS
[Enter code]
(to mute the buzzer)
Vacate the premises
ARM indicator lights during the armed state.
Remember: Forced arming compromises security!!
button during the exit delay will
RESULTANT DISPLAY
ENTER CODE
Code
ARMING AWAY
ARMING INSTANT
(alternating)
PLEASE EXIT NOW
↓ (Exit delay) ↓
AWAY
zones are disturbed
RESULTANT DISPLAY
ENTER CODE
Code
ARMING AWAY
PLEASE EXIT NOW
↓
(Exit delay)
AWAY
_ _ _ _
and the
_ _ _ _
↓
7