Table of Contents
Advertisement
By using
INSTALLER CODE
(see fig. 4.1a)
1. NEW INSTL CODE
1. NEW INSTL CODE
NEW MASTER CODE
NEW INST. CODE
MASTER CODE xxxx
INST. CODE xxxx
[code]
Figure 4.1c - Setting a New Installer Code
in System with Inst. & Master Inst. Codes (see note)
4.2 ENROLLING WIRELESS DEVICES AND KEYFOB TRANSMITTERS
4.2.1 General Guidance
The ENROLLING mode has the following sub-modes:
• ENROLLING TYPE (wireless devices)
• ENROLL SENSORS (including wireless repeater MCX-610).
• ENROLL
KEYFOB
transmitters)
• ENROLL WL 1WAY KP (wireless commander MCM-140+)
• ENROLL WL 2WAY KP (wireless 2-way keypad MKP-150/
MKP-151)
• ENROLL WL SIREN (wireless siren)
Before beginning, gather all the devices that you intend to
enroll and make sure they all have batteries installed.
Your control panel must recognize the unique identification
code (ID) of each such device in order to supervise them,
receive their signals and respond accordingly.
Attention! CodeSecure transmitters are mainly used for
arming/disarming and can not be enrolled to zones. In
order to enroll to zones, use only non-CodeSecure
wireless devices.
4.2.2 Enrolling Type
Here you determine whether to enroll a wireless device by
normal transmission or by device Tamper function
(opening its cover). Options: normal, or by tamper.
4.2.3 Enroll/Delete Sensors
Wired detector can be enrolled in zone 29 and wireless
detectors can be enrolled in zones 01-28.
• Before enrolling, the lens at the front of PIR
STOP
and dual-technology sensors should be
masked to prevent inadvertent transmission.
• Make sure that magnetic contact transmitter is
together with its magnet, to prevent it from sending
alarm transmission.
To enroll / delete wired / wireless sensors, refer to Fig. 4.2.
10
By using
MASTER INSTALLER CODE
(see fig. 4.1a)
NEW INST. CODE
INST. CODE xxxx
[code]
(multi-button
CodeSecure
Note: Installer Code should never be programmed as
"0000". Doing so will lock the user out of the installer menu!
[code]
4.2.4 Enroll/Delete Keyfob Transmitters
Keyfob transmitters are multi-button wireless CodeSecure™
transmitters. Eight system users use them for better,
quicker and safer control over various system functions.
To enroll / delete 1-way or 2-way keyfob transmitters, refer
to figure 4.2.
4.2.5 Enroll/Delete Wireless Commander
The Wireless Commander (MCM-140+) is a remote control
unit that enables the user to remotely control the system.
To enroll / delete up to 8 wireless commanders, refer to
figure 4.2 (Enroll WL 1-way KP).
4.2.6 Enroll/Delete 2-Way Keypad
The 2-way keypad, type MKP-150/MKP-151, enables the
user to remotely control the system and also to receive
data from the system (alarm and trouble data). To enroll up
to two 2-way keypads, refer to figure 4.2.
4.2.7 Enroll/Delete Wireless Siren
The wireless siren is a remote siren that is activated upon
predefined events by the PowerMaxExpress system. To
enroll / delete up to 2 wireless sirens, refer to figure 4.2.
D-302989
Advertisement
Table of Contents
