Casio CLASSWIZ CG Software User's Manual page 91

To select and input a built-in function
1. On the Function tab, highlight the line where you want to input.
2. Select T > [Built-In Function].
3. On the menu that appears, highlight the function you want to input and then press O.
• You can input the functions listed below.
y = Ax + B
2
y = A(x − B) + C
2
y = Ax + Bx + C
3 2
y = Ax + Bx + Cx + D
To edit or delete a function
To edit or delete an existing function, use the same operation as one in the Graph&Table app. See
function" (page 78) and
To change the line color for graph drawing
1. On the Function tab, highlight the function you want to change the line color of the graph.
2. Select T > [Line Color].
3. Use the list that appears to select a color.
To select a function to draw a graph
1. On the Function tab, highlight a line that contains an input function.
2. Press T.
• This displays a Tools menu with [Select] highlighted.
3. Change [Select] to
4. Press b to close the Tools menu.
• The on/off setting of step 3 is indicated by the icons to the left of each line of the Function tab.
... On
Note
• If multiple functions are selected on the Function tab for graphing, the message "Too Many Functions"
will appear on the Setup tab.
Using the Setup Tab
You can use the Setup tab to configure the settings described below, which appear when you press T.
To do this:
Specify the range of variation of
the coefficient value
Specify the speed that the
coefficient value changes
automatically during graph
drawing
"To delete a function" (page 78)
(On) to enable or to
... Off
Perform this operation:
1. Select T > [Range].
2. Input the starting value into the [Start] line, the ending value into the [End]
line, and the step value into the [Step] line.
3. To close the menu, press b twice.
1. Select T > [Speed].
2. On the menu that appears, highlight the setting you want and then press
O.
• You can select one of the speeds described below.
[Stop&Go]: Coefficient value changes with each press of l or r
instead of automatically.
[Slow]: Coefficient value changes at half of normal speed.
[Normal]: Coefficient value changes at normal speed.
y = Asin (Bx + C)
y = Acos (Bx + C)
y = Atan (Bx + C)
for more information.
(Off) to disable graphing for the selected function.
*
91
"To edit a