Casio CLASSWIZ CG Software User's Manual page 17

Changing the Display Format of Calculation Results (Format Menu)
Pressing sF *1
displays the Format menu, which you can use to change the display format of calculation
results.
Pressing sF and selecting
this:
π (Standard) Decimal
Sexagesimal
ENG Notation
Reverse ENG Notation
*1 When " Decimal" is selected for
*2 Form that includes a fraction, π , or
*3 Display ranges of conversions are limited. For information about the displays ranges of the fraction form
and form of the calculator's calculation results, see
" Form Calculation Range" (page
Operation Example:
Note
• Display format changes using the Format menu are also applied to the cell details.
• After entering a formula, pressing sE(J) instead of E displays the calculation results in decimal
form.
Fraction Form Calculation Results
How the calculator displays a fraction calculation result (fraction form or decimal form) depends on the number
of places required to express the result in linear form. The number of places is counted as shown below.
Proper fraction:
Three places. Two places digits for the numerator and denominator, one place for the separator ( ).
Improper fraction:
Five places. Three places for the integer, numerator, and denominator, and two places for the separators.
If the linear form of the calculation result has 10 digits or fewer, it is displayed in fraction form as shown in
Example 1 below. If it has 11 or more digits, it is displayed in decimal form as shown in Example 2 below.
1 = 123457
Example 1: 1
123456
Does this:
Switches the displayed calculation result between standard form
decimal form. Conversion to standard form is enabled when S > [ π
Result] > [On].
Switches the displayed calculation fraction result between mixed fraction and
improper fraction form. If the displayed calculation result is in decimal form,
selecting this form converts it to a fraction if conversion is possible.
Converts the displayed calculation result to degrees/minutes/seconds
(sexagesimal) form.
Converts the displayed calculation result to engineering notation form
n
(a × 10 form, where n is an integer multiple of 3). Each time you select
[ENG Notation], the current decimal point position in the mantissa is shifted
three places to the right (exponent is decreased by 3). Each time you select
[Reverse ENG Notation], the current decimal point position in the mantissa
is shifted three places to the left (exponent is increased by 3).
S > [FORMAT Key] (page 220)
18).
sF > [
π (Standard)
sF > [
π (Standard)
1
= 1 2
2
3 = 1 1
= 1 1 2
2 2
(Natural form) 1 1 123456 = 123457 123456 (Linear form)
123456
*3
"Fraction Form Calculation Results" (page 17)
2/j2E
Decimal]
Decimal]
17
*2
and
(initial default).
and