Casio CLASSWIZ CG Software User's Manual page 30

Statistical data:
1-Variable (no frequencies)
1-Variable (with frequencies)
2-Variable (no frequencies)
2-Variable (with frequencies)
*1 The method of statistical data creation for 1-Variable or 2-Variable statistical calculation is different from
that for performing hypothesis tests (page 42)
*2 This calculator displays list data used for 1-Variable statistical calculations as XList, list data used for
2-Variable statistical calculations as XList and YList, and list data used for frequencies as Freq or Frequency.
Frequencies
There are two ways to input statistical data: with frequencies and without frequencies (1 is used for all data
frequencies). You can specify which method you want to use on the Setup tab that appears when you press
> in List Editor, as shown in the example below.
Uses List1 for data.
Frequency of all data values: 1
Important!
• The values contained in a frequency list should be 0 or positive values only. Even a single negative
value causes an error (Out of Domain).
• Statistical data with a frequency of 0 is not used for calculation of minimum and maximum values.
Inputting Data in List Editor
You can use either of the two methods below to input data in List Editor.
Individual cell input
With this method, you input a value into a cell and then press E.
You can also input a calculation into a cell. If you do, the numeric value that is the result of the calculation is
entered immediately after you press E.
Batch input using the form {1,2,3,...}
Example: To input {1,2,3,4,5}
1. Use the cursor keys to highlight the name of the list you want to use.
2. Select C > [Statistics] > [{}], input the value, and then press E.
Assigning Other List Variables
You can assign List 1 data directly to List 2 or assign a
Example: To assign List 1+2 (adds 2 to each element of List 1) to List 2
1. Use the cursor keys to highlight list name List 2.
2. Input "List 1+2".
Required list variable(s):
One list variable to assign to XList
Two list variables to assign to XList and Freq
Two list variables to assign to XList and YList
Three list variables to assign to XList, YList and Freq
or finding confidence intervals (page
1`2`3`4`5E
list calculation (page 28)
30
*2
*2
*2
49).
Uses List1 for data.
Uses List2 for frequencies.
result to List 2.
*2