Casio CLASSWIZ CG Software User's Manual page 252

template or Plane template to draw multiple
3D graphs.
Relationship You tried to determine relationship without
requires two or more first using the Line template or Plane
objects. template to draw multiple 3D graphs.
(fx-CG100 only)
Geometry app errors
When you see this It means this:
message:
First select a You are attempting to construct a
segment. perpendicular bisector without first
selecting a line segment.
First select a line You are attempting to construct a
and point. perpendicular or parallel without first
selecting a line segment and point.
First select 2 points You are trying to construct a midpoint
or a segment. without first selecting two points or a line
segment.
First select the • You are trying to construct a point of
applicable figure.
• You are trying to execute T > [Animate]
• You are trying to execute T > [Animate]
First select 2 You are trying to construct an angle
segments. bisector without first selecting two line
segments.
Range ERROR View Window range settings exceeded.
You are trying to specify t0 = t1 on the Edit
Animations screen.
Too Many Objects! Work memory became almost full.
Too Many Objects! Work memory became full.
Work memory
cleared.
Invalid You are attempting to use the Expression
Measurement
command (T > [Option] > [Expression])
to input an expression that contains a
measurement that does not exist.
Too Many You are trying to add more than 10
Animations animations.
First select point(s). You are trying to execute T > [Animate]
> [Trace] without first selecting a point.
Too Many Trace You are trying to specify more than 10 trace
Points points.
intersection without first selecting two
lines.
> [Add Animation] or [Replace Animation]
without first selecting the required object.
> [Add Table] without first selecting the
required object.
Use the Line template or Plane template to
draw multiple 3D graphs and try again.
So you need to do this:
Select the required object(s) and then try
again.
Press F (Zoom to Fit) or select T
> [View] > [View Window] > [Pre-set
Windows] > [Initialize].
Specify different values for t0 and t1.
Delete objects you no longer need or open
a new file.
Delete objects you no longer need or open
a new file.
Check to make sure that the
expression you are inputting contains only
measurements that are currently on the
screen.
Use the Edit Animations screen to delete
animations you no longer need, or create a
new file and add new animations.
Select one or more points and try again.
Select up to 10 points and try again.
252