Casio CLASSWIZ CG Software User's Manual page 205

If you do this:
Turn power off and then back on again
Press the RESTART button
Remove the calculator's batteries
Delete Main Memory data
Re-entering the Exam Mode You are Currently In
You can re-enter an Exam Mode even if you are currently in an Exam Mode. Doing so discards any data you
input and settings you configured while currently in the Exam Mode and returns them to what they were when
you first entered the Exam Mode.
* The only settings retained is the Battery Settings in the System app.
1. While in an Exam Mode, highlight [Re-Enter Exam Mode] and then press O.
• This displays the "Re-Enter Exam Mode?" dialog on the calculator.
2. Press O.
• After the message "Re-Entering Exam Mode." is displayed for about three seconds, the calculator
automatically restarts and re-enters the Exam Mode.
Exiting an Exam Mode
There are three ways to exit an Exam Mode.
(1) Exiting an Exam Mode by Connecting to a Computer
*1
1. Use a USB cable to connect the calculator that is in an Exam Mode to a computer.
• This displays the "Select Connection Mode" dialog on the calculator.
2. Highlight [USB Flash / Unlock Exam Mode] and then press O.
• The message "Preparing USB" will appear on the calculator screen. Stand by and do not perform any
operation on the calculator.
• The screen shown to the right appears when a connection is
established between the calculator and the computer.
3. On the computer, open the calculator drive.
4. On the computer, copy or delete any file that is on the calculator drive.
5. On the computer, terminate the connection between the calculator and computer.
• Terminating a connection automatically causes the calculator to restart. This causes the calculator to exit
an Exam Mode and return to the state it was in before the Exam Mode was entered.
*1 Use of a genuine CASIO USB cable is recommended. If you plan to use a commercially available USB
cable, be sure to use a cable that can transfer data.
(2) Exiting an Exam Mode by Allowing 12 Hours to Elapse
Approximately 12 hours after entering an Exam Mode, turning on the calculator will cause it to exit the Exam
Mode automatically.
Important!
• If you press the RESTART button or if you replace batteries before turning on the calculator, it will
re-enter the Exam Mode when turned on, even if 12 hours have elapsed.
(3) Exiting an Exam Mode by Connecting to another Calculator
1. On the calculator that is in an Exam Mode (Calculator A), display the Exam Mode Manager menu.
The calculator stays in the
Exam Mode.
*
205
Data input in the Exam Mode
is retained.
Yes
Yes
Yes
Yes
Yes
No
No
No