Casio CLASSWIZ CG Software User's Manual page 197

• The following are single-byte characters that can be used in file names and folder names.
A-Z, a-z, 0-9, !, #, $, %, ,(comma), (, ), +, –, ., ;, =, @, [, ], ^, _, `, space
Note that file names and extensions are not case-sensitive.
Storage Memory Tab Operations
To load a g4m file into Main Memory
You can use the operation below to load g4m files
* Backup files created with Main Memory tab operations or individually saved files with Main Memory tab
operations.
Important!
• If duplicates of the data items below are found in step 2 of the procedure below, a confirmation message
will appear asking if you want to overwrite the existing data.
DYNA MEM, LIST n , LISTFILE n , MAT n , VCT n , Spreadsheet app data, data in the DBASE group,
data in the GEOM group
The data items below are always overwritten without displaying a confirmation message.
ALPHA MEM, CONICS, DIST, EQUATION, FINANCE, NUMINEQ (fx-CG100 only), RECURSION,
SETUP, STAT, SYSTEM, S-SHEET (_SETTING), TABLE, Y=DATA, 3DGRAPH, PROBSIM
For details about data contents, see
1. Highlight the g4m file you want to load into Main Memory.
2. Select T > [Load].
• This starts the load operation. During loading, a confirmation
message like the one on the right may appear. For more
information, see "Important!" above. To overwrite, select
[OK]. To cancel the operation, select [Cancel].
• The message Complete! appears on the display when the
load operation is complete.
Note
• In the cases described below, the load operation does not start when you select T > [Load] in step
2.
- When battery power is low (Low Battery error)
- When there is not enough free space in Main Memory (Memory Full error)
- When there are too many data items in Main Memory (Too Much Data error)
- When a file that is not a g4m file is selected (Invalid Type error)
To create a folder
1. Display the location (in the root directory or folder) where you want to create a folder.
• You can nest folders up to three levels.
2. Select T > [Folder] > [Make Folder].
3. Use the dialog that appears to input up to eight characters for the folder name and then press O.
To rename a folder
1. Highlight the folder you want to rename.
2. Select T > [Folder] > [Rename Folder].
3. Use the dialog that appears to input up to eight characters for the folder name and then press O.
*
into Main Memory.
"Data Displayed on the Main Memory Tab" (page
197
194).