IBM Flex System p24L Installation And Service Manual page 86

32. Have the customer reset the system date and time through the operating system that is installed.
For more information, see the documentation for your operating system.
33. If the part was replaced because of a service action, verify the repair by checking that the amber
enclosure fault LED is off. For more information, see "Compute node control panel button and
LEDs" on page 9.
What to do next
After replacing the system-board and chassis assembly, you must either update the system with the latest
firmware or restore the pre-existing firmware.
Completing the installation
To complete the installation, you must install and close the compute node cover, install the compute node
into the IBM Flex System Enterprise Chassis, and turn on the compute node.
Procedure
1. Install and close the compute node cover. See "Installing and closing the compute node cover" on
page 32.
Statement 21
CAUTION:
Hazardous energy is present when the compute node is connected to the power source. Always
replace the compute node cover before installing the compute node.
2. Install the compute node into the IBM Flex System Enterprise Chassis. See "Installing the compute
node in an IBM Flex System Enterprise Chassis" on page 76.
3. Turn on the compute node, as described in "Turning on the compute node" on page 10.
Note: If you have just connected the power cords of the IBM Flex System Enterprise Chassis to
electrical outlets, you must wait until the power-on LED on the compute node flashes slowly before
you press the power-control button.
4. If you installed an I/O expansion card, use the documentation that comes with the expansion card to
install device drivers and to perform any configuration that the expansion card requires.
5. For certain optional devices, run the compute node SMS Utility program, as described in "Using the
SMS utility" on page 18.
74
Power Systems: IBM Flex System p24L Compute Node Installation and Service Guide