IBM Flex System p24L Installation And Service Manual page 123

B1817204 • B1818BC1
B1817204
Explanation: Error reading boot parameters
Response: Go to Checkout procedure.
B1817205
Explanation: Boot code error
Response: Go to Checkout procedure.
B1817206
Explanation: Unit check timer was reset
Response: Go to Checkout procedure.
B1817207
Explanation: Error reading from NVRAM
Response: Go to Checkout procedure.
B1817208
Explanation: Error writing to NVRAM
Response: Go to Checkout procedure.
B1817209
Explanation: The service processor boot watchdog timer expired and forced the service processor to attempt a boot
from the other firmware image in the service processor flash memory
Response: Go to Checkout procedure.
B181720A
Explanation: Power-off reset occurred. FipsDump should be analyzed: Possible software problem
Response: Go to Checkout procedure.
B1818BC1
Explanation: The service processor reset failed to resolve a communication failure with the Chassis Management
Module. The service processor is no longer accessible.
Response: Perform the following actions one at a time until the problem is resolved:
1. Reseat the compute node.
2. Move the compute node to a different location in the chassis.
3. Perform a firmware update. See Updating the firmware.
If these actions do not resolve the problem, contact your next level of support. Reseating the compute node in a
chassis
111
Chapter 8. Troubleshooting