IBM Flex System p24L Installation And Service Manual page 44

3. Carefully lay the compute node on a flat, static-protective surface, with the cover side up.
4. Facing the unit, unlatch the cover by pressing the right cover release (as shown in the preceding
figures) on the compute node.
5. Press the right cover release while gripping the left cover release, slide the cover to the back of the
unit, and lift the cover open.
6. To protect the disk drives, which are on the inside of the cover, flip the cover over and lay it on a flat,
static-protective surface, with the cover side down.
Statement 12
CAUTION:
The following label indicates a hot surface nearby.
Statement 21
CAUTION:
Hazardous energy is present when the compute node is connected to the power source. Always
replace the compute node cover before installing the compute node.
Installing and closing the compute node cover
Install and close the cover of the compute node before you insert the compute node into the IBM Flex
System Enterprise Chassis. Do not attempt to override this important protection.
About this task
32
Power Systems: IBM Flex System p24L Compute Node Installation and Service Guide