Simons Voss Technologies SmartRelay 3 Manual page 40

SmartRelay 3 system
8.4.4 Solutions for scenarios
(Manual)
Switch one or several outputs via an optional SmartOutput module

chain.
The controller can also respond to a digital entry and, consequently, a
connected button or similar as an alternative to successful identification.
supplies electricity if necessary
reads out access lists
updates time budgets
writes authorisation changes
outputs signalling (optical, acoustic)
Reader 1
(mandatory)
forwards data from identifi-
cation media
Reader 2
Like reader 1
(optional)
Reader 3
Like reader 1
(optional)
The SREL3 ADV system is the time-tested solution for a large number of
use cases. This section presents a few of them and shows how the SREL3
ADV system is used. The wiring is basically always as described in terms of
electrics (see wiring [
}
installation options vary, depending on the use case.
NOTE
Protected areas are areas which can only be accessed with an authorised
identification media or are secured against unauthorised access in some
other way.
DANGER
Risk of injury due to incorrect programming
The SREL3 ADV system is not suitable to replace existing security installa-
tions.
1. Ensure that the SREL3 ADV system is used as an additional securing
measure only.
2. Do not replace existing security installations with the SREL3 ADV
system.
Controller
sends commands
for switching
SmartOutput module
(optional)
parallel
switching
SmartOutput module
(optional)
58] ). However, line lengths, cable types and wiring
8. Setting up
internal relay
sends commands to external
digital outputs devices. Available protocols
see specifications
digital inputs
Connection of external
devices (e.g. door openers)
Connection of external
devices (e.g. door openers)
40 / 189
Connection of external
devices (e.g. door openers)
Push-to-open at 3
Connection of external
devices (e.g. sensors)