Simons Voss Technologies SmartRelay 3 Manual page 33

SmartRelay 3 system
8.3.2 Resetting the controller
8.3.2.1 Resetting controller with a USB cable
(Manual)
10. Open the ▼ Type drop-down menu.
11. Select the "USB link to the TCP nodes" item.
12. Click on the Programming button.
9 Programming launches.
You need to reset the controller when changes are made to the connected
components. These include:
SmartOutput modules added

SmartOutput modules removed

Readers added

Readers removed

A reset deletes the programmed settings.
NOTE
Only the hardware settings and access lists on the controller are reset. The
IP setting remains unchanged
except for the IP settings made during initial programming. The controller
can still be reached using the saved IP address. This means you do not
necessarily need to establish a connection with a USB cable.
The controller can be reset with a USB cable. This option is ideal if the
controller has not yet been installed and can simply be reached physically.
Components wired correctly (see
ü
ü Components connected to power.
ü Controller connected to computer with USB cable.
1. Mark the entry on the SmartRelay 3 controller in the matrix.
wiring [ 58] ).
}
8. Setting up
33 / 189