Simons Voss Technologies SmartRelay 3 Manual page 167

SmartRelay 3 system (Manual)


Screw terminals

The max. current depends on the supply voltage and
the activity of the reader.
Supply via looped-through controller supply voltage
Controller
The max. current depends on the supply voltage and
powered
the activity of the reader.
Ambient conditions

Temperature
range

Humidity Max. 90%, non-condensing
Interfaces
Serves as an interface to the controller of the SREL3-
ADV system.
RS485




RFID

Interface to SimonsVoss transponders.

B-field

Signal
LED 1 RGB
Audio signal 1 piezo buzzer
Programming
V : 9 V – 32 V (Power supply must be limited to
IN DC DC
15 W)
Power input: max. 3 W
Reverse voltage protection: yes
-25 °C to +60 °C (operation)
0 °C to +30 °C (in storage > 1 week)
Number of ports: 1
Length: ≤ 150 m, abs. max. 300 m (depending on
firmware and cable)
13.56 MHz
Read range: 0 mm to 15 mm (depending on card
format)
Supported cards: Mifare Classic, Mifare DESFire
EV1/EV2)
Read range (approx.): 5 cm to 60 cm (
range mode, Gateway)
Read range (approx.): 5 cm to 100 cm (
range mode, Gateway)
14. Technical specifications
167 / 189
Close-up
Close-up