Minitower Slot Locations
The minitower system has five expansion slots on the rear
of the system with six connectors on the riser board:
n
three ISA slots (one of the ISA slots can only
accommodate a three-quarter length expansion card)
n
one shared PCI or ISA slot
n
one PCI slot.
Expansion board slot locations for the minitower system
are shown in the following figure.
The PCI/ISA shared slot accommodates either a full-length
PCI board or a full-length ISA board. If you are installing a
PCI board in the shared slot, it must be connected to the
second PCI connector on the riser board. If you are
installing an ISA board in the shared slot, it must be
connected to the ISA connector directly under the second
PCI connector.
Locating minitower expansion slots
Adding Options 6-17