Changing Jumper Settings
7-6 Setting System Board Jumpers
To change system board jumper settings, use the following
procedure. A label showing the jumper information is in-
side the system unit cover. The label provides a quick ref-
erence for the settings.
Turn off and unplug the system and any external
1.
options.
WARNING: The system power must be
off before changing a jumper setting.
Remove the system unit cover (see Chapter 5).
2.
Locate the jumper(s) on the system board (see the fig-
3.
ure under "Jumper Locations" earlier in this chapter).
You might have to remove installed expansion boards
to access the jumper (see expansion board removal
procedures in Chapter 6).
If you removed any expansion boards, replace them.
4.
Replace the system unit cover (see Chapter 5).
5.
Plug in system and peripheral cables and turn on the
6.
system.
Run Setup (see Chapter 2).
7.