Setting System Parameters; The Setup Utility - NEC POWERMATE VP Manual

2

THE SETUP UTILITY

Setting System
Parameters
This chapter describes the Setup utility program that al-
lows you to enter system configuration information and
control special features of the system.
Your system ships from the factory with the
correct system parameters for your configuration.
Unless you add optional hardware, you do not need
to run Setup to operate your system.
However, you might wish to run the Setup utility to
set features that customize your system, such as
security features.
System configuration information is stored in a comple-
mentary metal-oxide semiconductor (CMOS) chip backed
up by a battery in the real-time clock (RTC) chip on the
system board.
NEC recommends that you print out or
write down your current Setup parameters and store
the information in a safe place. This lets you restore
your system to the current parameters if you ever
need to replace the battery.
The Setup utility lets you view and set system parameters.
Use the Setup utility program

Setting System Parameters 2-1