NEC POWERMATE VP Manual page 143

n
Using equal pressure at the ends of the SIMM, push
it until it locks under the metal clips at the ends of
the socket.
Replace any expansion boards that you may have re-
3.
moved (see "Expansion Boards" earlier in this chapter).
CAUTION: IDE and diskette drive ca-
bles are not keyed to fit only in the correct position.
If you removed a cable to install the SIMMs, reinstall
the cable by aligning the red edge of the cable with
pin 1 of the connector on the system board.
Securing the SIMM
Adding Options 6-29