NEC POWERMATE VP Manual page 138

6-24 Adding Options
CAUTION: IDE and diskette drive ca-
bles are not keyed to fit only in the correct position. If
removing a cable to install the SIMMs, reinstall the
cable by aligning the red edge of the cable with pin 1
of the connector on the system board.
Check the memory in your system. non-multimedia
3.
systems ship with 8 MB (two 4-MB, 32-bit SIMMs) in
bank 0, on the system board. Multimedia configurations
come with two 8-MB (32-bit) SIMMs installed in
bank 0 for a total of 16 MB.
Fill both sockets in a bank when upgrading. Begin
SIMM installation using bank 0. Both sockets in a bank
must be filled with the same type of SIMM sticks (two
SIMM sticks with the same size and speed). Supported
SIMMs include:
n
4-MB SIMM stick (1 MB by 32 or 36 bit)
n
8-MB SIMM stick (2 MB by 32 or 36 bit)
n
16-MB SIMM stick (4 MB by 32 or 36 bit)
n
32-MB SIMM stick (8 MB by 32 or 36 bit)
n
64-MB SIMM stick (16 MB by 32 or 36 bit)
When using single-sided SIMMs, fill SIMM sockets
according to the following table.
Jumper JP1 on the system board must be
set on pin 2–3 when using single-sided SIMMs in
bank 0 (see Chapter 7, Setting System Board Jump-
ers).