NEC POWERMATE VE - SERVICE MANUAL 05-1996 Service Manual page 69

3-8 Option Installation
Figure Section 3-10 Removing the Slot Cover Support Screws
Hold the board by its edges, component side down and the bracket end facing the
4.
rear of the unit, and insert it into the expansion slot.
Press the board firmly into the expansion slot connector. Gently rock the board
from side-to-side to seat it into the connector.
5. Hold the slot cover support over the expansion board bracket and replace the two
screws removed earlier (see Figure Section 3-12). The slot cover support secures
the expansion board in place.
Figure Section 3-12 Attaching the Slot Cover Support
6. Attach any signal cables required by the expansion board.
7. Replace the system unit cover.
Expansion Board Slot Cover
Bracket Support
Slot Cover
Slot Cover Support
Screws
Screws