Replacing The Covers - NEC POWERMATE PROFESSIONAL 9000 Service Manual

6. Pull the top edge of the cover out about one-half inch from the top of the chassis.
7. Lift the cover up and away from the system unit.
Repeat this procedure if the other side cover must also be removed.
To replace the cover, see "Replacing the Covers."

Replacing the Covers

Replace the covers as follows:
1. Position the cover against the chassis with its front edge about one-half inch
behind the front of the chassis.
Fit the cover into the chassis. Make sure that the tabs along the top, back, and
2.
bottom edges of the cover are aligned with the notches and rails in the chassis.
NOTE: The cover fits tightly. You might need
to anchor one hand on the rear of the system unit
as you slide the cover.
Figure 3-3 Removing the System Unit Cover
CAUTION: To prevent damage to system
cables, carefully tuck the cables out of the path
of the cover.
Option Installation 3-5