3-28
Option Installation
Diskette Drive Cabling
The following procedure explains how to cable a diskette drive.
Connect the diskette drive signal cable connector to the signal connector on the
1.
diskette drive as shown in the following figure (see "Diskette Drive Signal
Cable").
Locate an available power connector coming from the power supply (see "System
2.
Power Cables").
3.
Connect the power cable to the power connector on the device.
Figure 3-21 Connecting 1.44-MB Diskette Drive Cables
Installing Storage Devices
The following subsections describe how to install 3 1/2-inch and 5 1/4-inch drives. The
installation procedures include:
T
removing the front panel
T
replacing the front panel
T
installing a 5 1/4-inch device
T
installing a 3 1/2-inch diskette drive
T
installing an internal 3 1/2-inch hard disk drive in an internal drive slot.