Table of Contents
Advertisement
Replacing the Cover
Replace the cover as follows.
crimping, abrasion, or cutting while installing the cover. Check that the ribbon cables are folded
along their fold lines and out of the direct path of the cover.
Position the cover over the side of the chassis so that the back edge of the cover is about an
1.
inch beyond the back edge of the chassis (see the following figure).
Align the tabs and slots on the cover with those along the edges of the chassis.
2.
Align the locking tab slot at the bottom rear of the cover with the locking tab.
3.
Firmly press the cover against the chassis and slide the cover towards the front of the
4.
chassis until it locks in place.
Removing the Cover
Ensure that all cables inside the chassis are positioned to prevent
Replacing the Cover
A – Side Slots and Tabs
B – Locking Tab (hidden)
C – Front Slots and Tabs
Disassembly and Reassembly 3-5
Advertisement
Table of Contents
